![4l60e shift kit plate 4l60e shift kit plate](https://i.ebayimg.com/thumbs/images/g/GDsAAOSw-KFXfpMA/s-l200.jpg)
Since the upgrade requires a complete teardown, a full rebuild, with a few extra performance pieces, is a good idea. The important thing to remember here is that the tranny type, PWM or non-PWM, must match the computer in the car, otherwise it will not function properly. A PWM-type tranny will be marked with “PWM” on the front of the pump. This type of lockup circuit offers a smoother transition as it pulses the signal instead of all at once. In 1995, GM converted the 4L60E converter lockup circuit to a Pulse Width Modulated circuit. This is important as while they share some parts, they are different transmissions. In 1993, when the 4L60E was introduced, the 700R4 was renamed 4L60. The 4L60E transmission is an electronically controlled unit, notated as such by the “E” after the name. A Rear Clutch Spring Compressor, Universal Pump Remover, Front Pump Alignment Band, Turbine Shaft Installer, and a Teflon Stator Shaft Installer, are all needed to properly disassemble and reassemble the 4L60E transmission. And there are a few specialized tools needed to correctly complete the job. This is not the most difficult tranny to build but it is certainly not the easiest.
![4l60e shift kit plate 4l60e shift kit plate](https://cdn.shopify.com/s/files/1/0153/8513/3156/products/2b0e7ad8-6372-4216-9d25-66a0bd77b3f3_1200x1200.jpg)
If you have never done this before, this may not be the time to start. Replacing the planetary carriers requires a full teardown. The nice thing about all of this is that the 5-lug parts are easily swapped into the 4L60E, leaving you with the ability to upgrade your existing tranny without having to buy a new unit. The 4L65E utilizes 5-pinion planetaries, along with a hardened input shaft, that boosted torque capacity to 380 ft.lbs. The 4L60E uses 4-pinion planetary carriers, these carriers are rated to 360 ft. The 4L65E was built on the same platform as the 60, but with a few differences. In 1994, GM started using the 4L60E in all rear-wheel drive cars, until 2001 when performance demands had increased beyond its current capacity, and it was replaced with the 4L65E. The descendent of the 700R4, the 4L60E trans has a long history of backing up some fairly potent motors. The 4L60E transmission has long been a mainstay in the General’s arsenal of transmissions.